After getting the Polyester Printing Mesh, what should we do to make it work the most?(2)
After getting the Polyester Printing Mesh, what should we do to make it work the most?(2)
mesh drying, washing mesh:: use grinding net cream to grease (new mesh), ghost shadow to graphics (old mesh), remove the pulp to the mesh, blue oil, wash the debris with anti-white water, wash the net with detergent Finally, rinse it with a high-pressure water gun and finally clean it with pure water. Baking mesh - oven setting temperature should be less than 48 degrees C. Sticking film: Wash the mesh and wash it with pure water. According to the engineering film, increase the pattern by about 20%, select the water film, press the end of the water film with the triangle ruler on the mesh, then use the triangle ruler to slowly scrape up, then use the rubber scraper to gently flatten the towel, wipe the excess water with a towel. Drying using mesh: drying the stencil and then sizing, using a scraping box, and packing the net pulp box to the net, where the green oil is three times, (about once every 10 minutes), the oil is twice. The blue gum first peeled off the film on 50K water film, and then 20 times the net pulp, three times each time (we have used automatic sizing machine), and dried after sizing. The choice of mesh yarn is 120T, 100T, 110T mesh for general line, green oil, base oil and surface oil, 51T for carbon oil, 24T for blue rubber, and 77K for heat-cured green oil. 18K water film for use. The mesh will be produced due to the unevenness of the net access to the mesh: dog teeth, fat oil, wave), green oil, base oil, surface oil selected mesh, carbon oil used 50K water film with the required engineering graphics film posted on the stencil The selected position is placed on the blasting machine for exposure, the time is selected (3000W spotlight), the line is generally 60-80 seconds, the green oil is 80-100 seconds, the bottom character oil is 40-60 seconds, carbon oil, blue glue 350- 400 seconds of pressurized water flushing mesh, dry. Seal the outer edge of the film with blue oil (sealing mortar) and dry it. Check, repair, write the date of completion and the corresponding number and record and store.
PREVIOUS： After getting the Polyester Printing Mesh, what should we do to make it work the most?(1)
NEXT：Introducing the basic process of screen printing mesh today(1)
