There are some notice you need to pay attention to when you inspect your welded wire mesh.
First, the wire diameter should compliance to contract, in general the tolerance not more than 0.2mm, We MAISHI WIRE MESH MANUFACTURE GROUP use micrometer to measure the wire diameter.
Second, weight, galvanized welded wire mesh weight calculation is suitable to following formulas:
1”x1/2” ： Wire Dia x Wire Dia x width x length ÷4 x 3= kg/roll
1/2” x 1/2”： Wire Dia x Wire Dia x width x length= kg/roll
1/3” x 1/3”： Wire Dia x Wire Dia x width x length x 3 x 0.48= kg/roll
1/4” x 1/4”： Wire Dia x Wire Dia x width x length x 2= kg/roll
3/4” x 3/4”： Wire Dia x Wire Dia x width x length÷ 2 x 1.33= kg/roll
3/8” x 3/8”： Wire Dia x Wire Dia x width x length x 1.35= kg/roll
5/8” x 5/8”： Wire Dia x Wire Dia x width x length÷5 x 8÷2= kg/roll
2” x 4”：Wire Dia x Wire Dia x width x length÷2x 0.375= kg/roll
1” x 2”：Wire Dia x Wire Dia x width x length÷2x 0.75= kg/roll
2” x 3”：Wire Dia x Wire Dia x width x length÷2x 0.415= kg/roll
Remark: Wire dia is mm, width and length is m
Third, material, electro galvanized is more shinny than hot dipped galvanized, also the zinc coating layer is thinner; for pvc coated you also need to scratch the pvc coating to identify inner material.
Forth, measuring mesh opening whether meet the requirements.
Fifth, check the welding point whether is qualified, whether snap or solder skips
The last is whether packing is good.
We MAISHI WIRE MESH MANUFACTURE GROUP are your specialist of welded wire mesh, to help you avoid risky and choose right products.
If you need more information about our welded wire mesh, welcome to visit www.maishimfg.com or send email to [email protected], MAISHI WIRE MESH MANUFACTURE GROUP at your service all the time.
