The following are some printing process parameters from MAISHI wire mesh manufacturer Group. Please check:
Printing process parameters table
|
Printing method |
Network distance |
Scraper | ||
|
Materials |
Diamention |
Printing angle |
||
|
Manual or mechanical (Mainly for Manuall) |
Usually the distance is 3-5mm(According to the mesh area) |
Polyurethane rubber Thickness: 8-12mm Hardness: Shore A 50 to 60 degrees |
The length should be wider than the screen printed graphic about 20-30mm The height of the adhesive strip leakage handle is 20-30mm |
60°-70° 45°is the best |
If you need more details about printing, you may contact us at [email protected]
PREVIOUS： First
NEXT：Calculation of the finest line Width of the printing ink in screen printing process
